Alert Messages - Ricoh SGC 1506 Operating Instructions Manual

Troubleshooting When Using the Printer Function

Alert Messages

This section describes the machine alert messages.
Message
Option RAM Error
Connect
failed:IEEE802.
11b / Prob-
lem:IEEE802.11b
card / Prob-
lem:IEEE802.11b
board
4
Prob-
lem:IEEE1394
board
HDD functional
problems.
USB Error
Ethernet Board
Error
Privileges are
required to use
this function.
Authentication
failed.
Parallel I/F Er-
ror
File System Er-
ror.
Printer Font Er-
ror.
42
Cause
There is a problem with the RAM. Replace the RAM.
• IEEE 802.11b interface unit
was not inserted when the
machine was turned on, or it
was pulled out after the ma-
chine turned on.
• The settings are not updated
although the unit is detected,
or errors are found while ac-
cessing the unit.
An error may have occurred in
the IEEE 1394 board.
An error has occurred in the hard
disk drive.
An error has occurred in the USB
interface.
An error has occurred in the Eth-
ernet board.
Use of this function is restricted.
• The login user name or pass-
word entered is incorrect.
• The machine currently cannot
perform authentication.
An error has occurred in the par-
allel interface board.
A file system error has occurred.
An error has occurred in the font
settings.
Solution
Turn off the machine and check
the IEEE 802.11b interface unit is
inserted correctly. Then, turn the
machine on again. If the message
appears again, call your service
representative.
Turn off the main power switch,
and back on again. If the message
appears again, contact your sales
or service representative.
Turn off the main power switch,
and back on again. If the message
appears again, contact your sales
or service representative.
Turn off the main power switch,
and back on again. If the message
appears again, contact your sales
or service representative.
Turn off the main power switch,
and back on again. If the message
appears again, contact your sales
or service representative.
Contact the administrator.
• Check your login user name
and password.
• Contact the administrator.
Turn off the main power switch,
and back on again. If the message
appears again, contact your sales
or service representative.
Check whether the selected PDF
file has been corrupted.
Contact your service representa-
tive.