When Memory Is Full - Ricoh C3030 Operating Instructions Manual

❖ Duplex
Problem
Cannot print in duplex
mode.
Cannot print in duplex
mode.
Cannot print in duplex
mode.
Copies are not in cor-
rect order.
When using Duplex,
copy is made Top to
Bottom even though
[Top to Top] is selected.

When Memory is Full

This section explains likely causes of and possible solutions for problems related
to full memory.
Message
Memory is full.
nn originals
have been
scanned.Press
[Print] to copy
scanned origi-
nals. Do not re-
move remaining
originals.
"n" in the message rep-
resents a changeable
number.
Press [Resume]
to scan and copy
remaining origi-
nals.
Cause
You have loaded paper on the by-
pass tray.
You have loaded paper exceed-
2
ing 90 g/m .
You have selected a tray which is
set to [1 Sided Copy] in [Tray Paper
Settings] in [System Settings].
You placed the originals in the in-
correct order.
You placed the originals in the
wrong orientation.
Cause
The scanned originals exceeds
the number of pages that can be
stored in memory.
The machine checked if the re-
maining originals should be cop-
ied, after the scanned originals
was printed.
When You Cannot Make Copies as Wanted
Solution
Remove paper loaded on the by-
pass tray. Load paper in another
tray.
Change the paper.
Set the tray to [2 Sided Copy] in
[Tray Paper Settings] in [System Set-
tings]. See "System Settings",
General Settings Guide.
When placing a stack of originals
in the ADF, the last page should
be on the bottom.
If you place an original on the ex-
posure glass, start with the first
page to be copied.
Place the original in the correct
orientation. See "Original Orien-
tation", Copy/Document Server
Reference.
Solution
Press [Cancel] to copy scanned
originals and cancel the scanning
data. Press [Clear Memory] to can-
cel the scanning data and not
copy.
To continue copying, remove all
copies, and then press [Resume
Printing]. To stop copying, press
[Cancel].
2
25