Ricoh C3030 Operating Instructions Manual page 418

Troubleshooting When Using the Copy Function
Problem
In Margin Adjustment
mode, parts of the orig-
inal image are not cop-
ied.
2
In Margin Adjustment
mode, parts of the orig-
inal image are not cop-
ied.
In Image Repeat mode,
the original image is
not copied repeatedly.
❖ Stamp
Problem
The stamp position is
wrong.
❖ Combine
Problem
You cannot make a
book from Booklet or
Magazine mode by
folding copies.
When using Combine,
parts of the image are
not copied.
Copies are not in cor-
rect order.
24
Cause
You set a wide erased margin.
There is a lack of margin space on
the opposite side of the binding
position.
You selected copy paper the same
size as the originals, or you did
not select the proper reproduc-
tion ratio.
Cause
The paper orientation is wrong.
Cause
You selected a setting ("Open to
left"or "Open to right") that does
not match the orientation of orig-
inals.
You specified a reproduction ra-
tio that does not match the sizes
of your originals and copy paper.
You placed the originals in the in-
correct order.
Solution
Set a narrower margin with User
Tools. You can set the width be-
tween 0-30 mm (0"-1.2").
See "Front Margin: Left/Right",
"Back Margin: Left/Right",
"Front Margin: Top/Bottom"
and "Back Margin: Top/Bot-
tom", General Settings Guide.
Set a narrower margin with User
Tools. You can set the width be-
tween 0-30 mm (0"-1.2").
See "Front Margin: Left/Right",
"Back Margin: Left/Right",
"Front Margin: Top/Bottom"
and "Back Margin: Top/Bot-
tom", General Settings Guide.
Select copy paper larger than the
originals or select the proper re-
production ratio.
Solution
Check the paper orientation and
stamp position.
Solution
Change the setting. See "Orienta-
tion: Booklet, Magazine", Gener-
al Settings Guide.
When you specify a reproduction
ratio using Manual Paper Select
mode, make sure that the ratio
matches your originals and the
copy paper. Select the correct re-
production ratio before using
Combine mode.
When placing a stack of originals
in the ADF, the last page should
be on the bottom.
If you place an original on the ex-
posure glass, start with the first
page to be copied.