To Turn Off Gas To Appliance - Vermont Castings Radiance RADVTSCCB Installation And Operating Instructions Manual

Radiance Direct Vent Gas Heater
®
LIGHTING AND OPERATING INSTRUCTIONS
1. STOP! Read the safety information above.
2. This appliance is equipped with an ignition device which automatically lights the burner. Do not try
to light the burner by hand.
3. With five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell
gas, STOP! Follow "B" in the safety information on Page 34. If you do not smell gas, go to next
step.
4. Press the master switch to the "ON" (-) position. Within eight (8) seconds it will beep once. This
indicates the system is ready.
5. Press "ON " button. Sparker will spark and pilot flame will light.
6. Once pilot flame is established, the main burner flame will light automatically.
7. If the pilot will not stay lit after several tries, turn the master switch to "OFF" and call your service
technician or gas supplier.
OFF
FP1913
Switch box
8/08
1. Turn master switch to "OFF".
2. Turn off all electrical power to the appliance if service is to be performed.
20306759
FOR RADVTSC MODELS
OFF
ON
Command Center

TO TURN OFF GAS TO APPLIANCE

Master
Switch
ON
OPERATING INSTRUCTIONS
FP1914
Pilot w sparker
8/08
35