Vermont Castings Radiance RADVTSCCB Installation And Operating Instructions Manual page 25

Radiance Direct Vent Gas Heater
®
Before installation, inspect ember bed burner for damage.
Do not use ember bed if damaged or cracked. Small, shal-
low surface cracks are acceptable.
1. Remove the logs from their packaging and inspect
each piece for damage. DO NOT INSTALL DAM-
AGED LOGS.
2. Install the rear log by placing it on the ember bed
toward the back of the firebox. (Figure 42) The log
should touch the back wall of the firebox. When the
log is in place, the two (2) notches on the bottom of
the log rest on the two (2) ribs on the back side of the
ember bed. (Figure 43)
Fig. 42 Rear Log
LG488
Ribs for Rear Log
rear log
6/07
Rib Flat Spot for
Front Left Log
Fig. 43 Ribs for Logs
LG487
ember bed
6/07
20306759
Rear Log
LG488
Ember Bed
Rib and Flat Spot
for Front Right Log
LG487
ASSEMBLY AND INSTALLATION
3. Install the front left and right logs (Figure 44) by plac-
ing them on the ribs shown in Figure 43. Make sure
the logs line up with the flat spots on the ember bed
intended for location purposes. (Figure 43)
4. Install the left cross log by engaging the hole on the
bottom with the pin on the left side of the rear log. Set
front side of cross log on notch in ember bed. (Figure
45)
5. Install the right cross log by engaging the hole on the
bottom with the pin on the right side of the rear log.
Set front edge of cross log on ember bed as shown
in Figure 45.
Front Left Log
Fig. 44 Front Logs
LG489
front logs
Left Cross
6/07
Log
Front Left Log
Fig. 45 Completed Installation
Front Right Log
Right
Rear Log
Cross Log
LG490
Ember Bed
LG490
all logs
6/07
LG489
Front
Right Log
25