Assembling The Stove - Vermont Castings Radiance RADVTSCCB Installation And Operating Instructions Manual

ASSEMBLY AND INSTALLATION

ASSEMBLING THE STOVE

Tools Required
• Phillips screwdriver (stub)
• Utility knife
• Metal drill bit: size 28 (.140"/3.5mm)
• Flat-blade screwdriver
• Power drill
• Reciprocating saw
• 9/16" wrench
Parts Bag Contents:
• Three (3) Vent Screws
• Two (2) Switch bracket screws
• Wood handle w/insert lifter (handle for operable door)
• Restrictor Plate
• 4" Starter pipe
• On-Off switch, housing, and wiring harness
• Three (3) Phillips round-head bolts, 1/4"- 20 x 1/2"
• One (1) Tube of Vent Gasket Cement
• Four (4) CS, Hex Hd 3/8-16 x 1 Gr 2-Z
• Four (4) Washer, Fl 3/8-Z
• LP Conversion Kit
• Homeowner's Installation and Operating Manual
Unpack and Assemble Legs
The Radiance is shipped upright. Cut the shipping straps
before beginning assembly.
1. Slide stove to the rear of the pallet just far enough to
access rear leg holes. Make sure the stove does not
tip over backwards. (Figure 13)
2. Attach the rear legs using 3/8" hex head bolts and
flat washer supplied. Tighten with a 9/16" wrench
or socket. Remove and discard the large slot-head
screws using the flat-blade screwdriver.
3. Carefully tip the stove onto its rear legs. Adjust the
pallet to allow access to one of the front leg holes. Be
sure to leave the pallet under the stove to prevent the
stove from falling fully forward. (Figure 14)
CAUTION
To prevent valve tubing from being crushed or damaged,
do not rest valve or ignitor on wooden pallet.
1414
Radiance
Fig. 13 Slide stove back just far enough to access rear leg holes.
ST720
Radiance
slide stove back
7/30/02 djt
ST721
Fig. 14 Carefully tip stove onto back legs. Leave pallet under
stove to keep stove from falling fully forward.
4. Have your assistant attach one leg using the hard-
ware described.
5. Move the pallet to allow access to the other front leg
hole. Attach remaining leg.
6. Remove pallet and allow stove to gently rest on all
four legs.
7. Adjust leg levelers to compensate for irregularities in
the hearth.
NOTE: Verify the two relief doors (located on top of
the firebox) are properly seated on the gasket. The
doors should sit flush on the gasket, and should
lift easily from the seal around the opening.
Direct Vent Gas Heater
®
Washer
Hex Head Bolt
ST721
Radiance
attach
front legs
7/30/02 djt
20306759
ST720