Fax Memory Full - Lexmark MX310 User Manual

Troubleshooting
Defective flash detected [51]
Try one or more of the following:
•
Replace the defective flash memory card.
•
From the printer control panel, select Continue to ignore the message and continue printing. For
non‑touch‑screen printer models, press
•
Cancel the current print job.
Error reading USB drive. Remove USB.
An unsupported USB device is inserted. Remove the USB device, and then insert a supported one.
Error reading USB hub. Remove hub.
An unsupported USB hub has been inserted. Remove the USB hub, and then install a supported one.

Fax memory full

From the printer control panel, touch Continue to clear the message.
Fax partition inoperative. Contact system administrator.
Try either of the following:
•
From the printer control panel, select Continue to clear the message. For non‑touch‑screen printer
models, press
•
Turn the printer off, and then turn it back on. If the message appears again, then contact your system
support person or see the "Setting up the printer to fax" section of the User's Guide.
Fax server 'To Format' not set up. Contact system administrator.
Try either of the following:
•
From the printer control panel, select Continue to clear the message. For non‑touch‑screen printer
models, press
•
Complete the Fax Server setup. If the message appears again, then contact your system support
person.
Fax Station Name not set up. Contact system administrator.
Try either of the following:
•
From the printer control panel, select Continue to clear the message. For non‑touch‑screen printer
models, press
•
Complete the Analog Fax Setup. If the message appears again after completing the setup, then contact
your system support person.
to confirm.
to confirm.
to confirm.
to confirm.
179