Parking Brake Cable Removal And Installation; Parking Brake Lever Removal And Installation - Suzuki 2006 SX4 Service Manual

Parking Brake Cable Removal and Installation

Removal
NOTE
When it is necessary to remove both right
and left parking brake cables, repeat below
steps 2) and 6) on right and left wheels.
1) Hoist vehicle.
2) Remove wheel.
3) Disconnect parking brake cable from equalizer
(parking brake lever) and clamps.
4) Remove parking brake cable and parking cable
bracket.
Installation
Install it by reversing removal procedure, noting the
following points.
• Install clamps properly referring to "Parking Brake
Cable Construction".
• Tighten bolts and nuts to specified torque referring to
"Parking Brake Cable Construction".
• Adjust parking brake cable. Refer to "Parking Brake
Lever and Cable Inspection and Adjustment".
• Check brake disc for dragging and brake system for
proper performance. Brake test should be performed.

Parking Brake Lever Removal and Installation

Removal
1) Remove console box.
2) Block vehicle wheels and release parking brake
lever.
3) Disconnect lead wire of parking brake switch at
coupler.
4) Loosen parking brake cable adjusting nut (1).
5) Remove parking brake lever bolts (1) and then
S6RW0C4406002 remove parking brake lever assembly (2) with
equalizer (3).
NOTE
Don't disassemble parking brake lever
switch. It must be removed and installed as a
complete switch assembly.
Installation
1) Install in reverse order of removal procedure.
Check equalizer inclined angle.
Tightening torque
Parking brake lever bolt (a): 26 N·m (2.6 kgf-m,
S6RW0C4406003
19.0 lb-ft)
2) After all parts are installed, parking brake lever
needs to be adjusted. Refer to "Parking Brake Lever
and Cable Inspection and Adjustment".
I4RS0A440004-01
3) Check disc brake for dragging and brake system for
proper performance. After removing vehicle from
hoist, brake test should be performed.
Parking Brake: 4D-3
I5RW0A440002-01
I5RW0A440003-01