Induction Heater Magnetic Erase Board (Ihmeb) Removal - Lexmark MS911 Service Manual

5
Remove the seven screws (A), and then remove the shield.

Induction heater magnetic erase board (IHMEB) removal

1
Remove the scanner interface cable cover. See
2
Remove the controller board access cover. See
3
Remove the engine board cover. See
4
Remove the upper rear cover. See
5
Remove the induction heater power supply shield. See
6
Disconnect the four cables (A).
"Scanner interface cable cover removal" on page
"Controller board access cover removal" on page
"Engine board cover removal" on page
"Upper rear cover removal" on page
"IHPS shield removal" on page
Repair information
291
289.
289.
290.
4021
286.
287.