Empty The Hole Punch Box; Error Reading Usb Drive. Remove Usb; Error Reading Usb Hub. Remove Hub; Incorrect Paper Size, Open [Paper Source] [34] - Lexmark MS911 Service Manual

Empty the hole punch box

Try one or more of the following:
•
Empty the hole punch box.
•
Select Continue on the printer control panel to clear the message and continue printing.
• Cancel the print job.

Error reading USB drive. Remove USB.

An unsupported USB device is inserted. Remove the USB device, and then insert a supported one.

Error reading USB hub. Remove hub.

An unsupported USB hub has been inserted. Remove the USB hub, and then install a supported one.

Incorrect paper size, open [paper source] [34]

Try one or more of the following:
• Load the correct paper size and type in the tray or feeder, and then specify the paper size and type in the Paper
menu on the control panel.
•
Make sure that the correct paper size and type are specified in Print Properties or the Print dialog settings.
•
Check the length and width guides and make sure that the paper is loaded properly in the tray or feeder.
• From the control panel, touch Continue to clear the message and then print using a different tray.
•
Touch Reset active bin to reset the active bin for a linked set of bins.
•
Cancel the print job.

Insert hole punch box

Insert the hole punch box into the finisher, and then touch Continue to clear the message.

Insert Tray [x]

Try one or more of the following:
• Insert the specified tray into the printer.
•
Cancel the print job.
•
Reset the active bin for a linked set of bins by selecting Reset active bin on the printer control panel.

Insufficient memory for Flash Memory Defragment operation [37]

Try one or more of the following:
• From the printer control panel, touch Continue to stop the defragmentation and continue printing.
•
Delete fonts, macros, and other data in the printer memory.
•
Install additional printer memory.
Diagnostic information
102
4021