Unsupported Disk; Unsupported Option In Slot [X] [55]; Waste Toner Bottle Nearly Full [82.Xy]; Weblink Server Not Set Up. Contact System Administrator - Lexmark MS911 Service Manual

Unsupported disk

Remove the unsupported printer hard disk, and then insert a supported one.

Unsupported option in slot [x] [55]

1
Turn off the printer.
2
Unplug the power cord from the electrical outlet.
3
Remove the unsupported option card from the printer controller board, and then replace it with a supported card.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.

Waste toner bottle nearly full [82.xy]

You may need to order a waste toner bottle. If necessary, touch Continue on the printer control panel to clear the
message and continue printing.

Weblink server not set up. Contact system administrator.

From the printer control panel, touch Continue to clear the message.
Note: If the message appears again, then contact your system support person.

User attendance messages

User attendance messages (0‑99)
Error code Description
31 A supply‑related error was detected:
•
The cartridge is missing or undetected.
•
The photoconductor is missing or undetected.
•
The cartridge is defective.
•
The photoconductor is defective.
32 The cartridge or photoconductor is unsupported.
34 Paper size mismatch was detected.
35 The printer memory is insufficient to enable
Resource Save.
37 The printer memory was insufficient to do the job.
38 Memory is full.
39 The page is too complex to print.
Action
See "Cartridge or photoconductor error service
check" on page
See "Mismatched paper size service check" on
page 114.
See "Insufficient memory service check" on
page 115.
See "Complex page service check" on page
Diagnostic information
112
113.
4021
115.