Ihps Shield Removal - Lexmark MS911 Service Manual

4
Disconnect the four cables (A), and then remove the two screws (B).
5
Remove the cover.

IHPS shield removal

Note: This part is not a FRU.
1
Remove the scanner interface cable cover. See
2
Remove the controller board access cover. See
3
Remove the engine board cover. See
4
Remove the upper rear cover. See
"Scanner interface cable cover removal" on page
"Controller board access cover removal" on page
"Engine board cover removal" on page
"Upper rear cover removal" on page
Repair information
290
289.
289.
4021
286.
287.