Oce DFS10 Operator's Manual page 61

Problem solving
Areas F9, F10, F11, F2, F3, F4
To clear a jam in areas F9, F10, F11, F2, F3 or F4, do the
following:
1. Read the instructions in the Message Display.
2. Use the Mimic Display to locate the jam.
3. Open the Left Front Door.
4. Open the Operator Jam Clearance Handle.
5. Follow the instructions on the jam clearance label(s) to
remove the copy set, cover, and any obstruction.
NOTE: Check the copy set and cover for damage. If the
copy set and cover are undamaged, save them for manual
processing into bound books. For further information,
refer to the "Manual processing of copy set and covers
removed during jam clearance" section of this chapter.
6. Close the Operator Jam Clearance Handle.
WARNING: Close the Left Front door as soon as you clear the
jam. If you leave the door open too long, any books waiting in
the Binder Module area will overheat. This will result in
defective binding and warped books.
7. Close the Left Front Door.
8. Do one of the following:
a. If the Binder is in the on-line mode, proceed to step 9.
b. If the Binder is in the manual mode, insert the next
copy set or copy set with cover into the Manual Feeder
and press the Manual Start button. Ignore the
remaining steps in this procedure.
9. Read the instructions in the Message Display.
10.Follow the directions on the host machine User Interface
screen.
55