Oce DFS10 Operator's Manual page 41

Making the books
b. For landscape (horizontal) page orientation, insert the
copy set with the cover so that the top page of your
copy set faces the right side of the DFS10 (as the word
Océ is shown in the figure) and the cover spine faces
downward into the Manual Feeder.
NOTE: Follow the orientation labels on the Manual
Feeder area of the DFS10.
5. Press the Manual Start button on the Control Panel of the
DFS10.
NOTE: If you are binding more than one book, you can
streamline the process by feeding the sets within 15
seconds of each other. Doing so eliminates the need to
press the Manual Start button for each book.
6. Retrieve the bound books from the Output Tray of the
DFS10.
NOTE: The entire binding process for each copy set takes
about two minutes from the time the copy set enters the
DFS10 until it is available as a bound book in the Output
Tray of the DFS10.
NOTE: When the books exit the DFS10, you can handle
them and browse through them. You should not, however,
allow them to lie open until the glue in the cover spine has
cooled and reached full strength. The recommended cool-
down time depends on the width of the spine and the
number of books. Refer to the book cool-down table in
chapter 7, "Technical data".
NOTE: Move the Book Guide to the left. This will allow
you to remove the books without causing damage to the
covers.
35