Oce DFS10 Operator's Manual page 60

54
Jam clearance procedures
Below are the procedures for clearing DFS10 jams.
Area F1
To clear a jam in Area F1, do the following:
1. Read the instructions in the Message Display.
2. Use the Mimic Display to locate the jam.
3. Open the Set Collating Door.
4. Follow the instructions on the jam clearance labels inside
the Interface Module to remove the copy set and any
obstruction.
NOTE: Check any sheets removed from the DFS10 for
damage and integrity. If the sheets are undamaged, save
them for manual processing into bound books through the
Manual Feeder. For further information, refer to the
"Manual processing of sheets and covers removed during
jam clearance" section of this chapter.
WARNING: Close the Set Collating Door as soon as you clear
the jam. If you leave the door open too long, any books waiting
in the Binder Module area will overheat. This will result in
defective binding and warped books.
5. Close the Set Collating Door.
6. Read the instructions in the Message Display.
7. Follow the directions on the host machine User Interface
screen.
NOTE: Check any sheets removed from the host machine
for damage. If the sheets are undamaged, save them for
manual processing into bound books through the Manual
Feeder. For further information, refer to the "Manual
processing of sheets and covers removed during jam
clearance" section of this chapter.
Problem solving