Oce DFS10 Operator's Manual page 51

Customising your Océ DFS10
1. Enter the Customer Tools mode as instructed in the previous
Security Code
section of this chapter.
2. Press the New Job button until Change Code appears on the
second line of the Cover Supply Contents Display.
3. Press the Manual Start button to accept Change Code.
CAUTION: Be certain to record your five-button entry
somewhere, because the buttons you press and the order in
which you press them will become your new Security Code.
4. Enter a new five-button Security Code.
NOTE: You can use any combination of the Language,
Reset, Energy Saver, Stop, and New Job buttons. You cannot
use the Manual Start button.
5. Press the new five-button Security Code a second time for
verification.
NOTE: If your second entry does not match your first, a
message will advise you that the Security Code is not the
same. Press the Manual Start button to begin the feature
again.
6. Do one of the following:
• Press the New Job button until the next feature you want to
• Press the Reset button to exit the Customer Tools features.
change appears on the second line of the Cover Supply
Contents Display.
45