Oce DFS10 Operator's Manual page 49

Spine Width Units Display
Customising your Océ DFS10
1. Enter the Customer Tools mode as instructed in the previous
section of this chapter.
2. Press the New Job button until Units appears on the second
line of the Cover Supply Contents Display.
3. Press the Manual Start button to select Units.
4. Press the Manual Start button to display the desired Units
measurement.
NOTE: You can select "metric" or "inch" As you press the
Manual Start button, you will switch between the two choices.
5. Press the Stop button to save the setting and exit the Units
feature.
6. Do one of the following:
• Press the New Job button until the next feature you want to
change appears on the second line of the Cover Supply
Contents Display.
• Press the Reset button to exit the Customer Tools features.
43