Oce DFS10 Operator's Manual page 63

Problem solving
Areas F8
To clear a jam in areas F8, do the following:
1. Read the instructions in the Message Display.
2. Use the Mimic Display to locate the jam.
3. Open the Right Front Door.
4. Follow the instructions on the jam clearance label(s) to
remove the cover and any obstruction.
NOTE: Check the cover for damage. If the cover is
undamaged, save it for manual processing into bound
books. For further information, refer to the "Manual
processing of copy set and covers removed during jam
clearance" section of this chapter.
WARNING: Close the Right Front door as soon as you clear
the jam. If you leave the door open too long, any books waiting
in the Binder Module area will overheat. This will result in
defective binding and warped books.
5. Close the Right Front Door.
6. Do one of the following:
a. If the Binder is in the on-line mode, proceed to step 7.
b. If the Binder is in the manual mode, insert the next
copy set or copy set with cover into the Manual Feeder
and press the Manual Start button. Ignore the
remaining steps in this procedure.
7. Read the instructions in the Message Display.
8. Follow the directions on the host machine User Interface
screen.
57