Table of Contents
Advertisement
Condition
Books are warped or have
spine damage.
The DFS10 Interface
Module fail to initiate.
The display is dark.
Problem solving
Causes
The force of the ejection of the
books into the Output Tray
causes damage to the spine.
The doors of the DFS10 were
left open too long during jam
clearance. Any books left
waiting in the Binder Module
were damaged due to
overheating.
The sensor/-s is/are covered,
loose or damage. The motor/-s
is/are damage.
There could have been a
thunderstorm/ lightning stroke.
Suggested solutions
Empty the Output Tray more
frequently.
Close the DFS10 doors
immediately after clearing a
jam.
Call for service.
NOTE: You can still run the
DFS10 manually. Move the
Bridge to set the DFS10 in
Manual Feed mode.
Reset the DFS10. Turn the
DFS10 off, the Power Switch
in the Off (0) position. Then
start the DFS10, the Power
Switch in the On (I) position.
63
Advertisement
Table of Contents
