Oce DFS10 Operator's Manual page 48

Changing the Customer Tools features
The table below contains the steps for changing each of the Customer Tools features.
Customer Tools feature
42
Energy Saver 1. Enter the Customer Tools mode as instructed in the previous
section of this chapter.
2. Press the Manual Start button to select Energy Saver from
the second line of the Cover Supply Contents Display.
NOTE: Energy Saver is the default selection each time you
enter the Customer Tools mode.
3. Press the New Job button until the desired Hours setting is
displayed.
NOTE: You can select from 0 to 12. As you press the New
Job button, the hours increment by one until you reach 12. The
cycle then begins again at 0.
NOTE: If 0 hours and 0 minutes are selected, the timed
Energy Saver mode is disabled.
4. Press the Manual Start button until the desired Minutes
setting is displayed.
NOTE: You can select 0, 15, 30 or 45. As you press the
Manual Start button, the minutes increment by 15 until you
reach 45. The cycle then begins again at 0.
5. Press the Stop button to save the settings and exit the Energy
Saver feature.
6. Do one of the following:
• Press the New Job button until the next feature you want to
•
What to do
change appears on the second line of the Cover Supply
Contents Display.
Press the Reset button to exit the Customer Tools features.
Customising your Océ DFS10