Table of Contents
Advertisement
Product specifications
The table below contains the product specifications for the DFS10.
Automatic operation
Binding speed
Book output time
Book capacity
Output Tray capacity
Cover Tray capacity
Warm-up time
Electrical requirements
Environmental requirements
Machine dimensions
Machine weight
Noise level
Power consumption
Heat output
66
The DFS10 is shipped with a Third Party Enablement Kit. The kit
enables the DFS10 to operate as an accessory to the host
machine. Each kit is for one host machine only. Additional host
machines require additional kits.
Accepts approximately one copy set per 2 seconds
Approximately 2.0 minutes from the time of entrance of a copy set
into the DFS10 until the book is available in the Output Tray
- On-line: 1 to 120 sheets
- Manual: 1 to 120 sheets
20 to 80 books depending on the spine width
- Cover Tray 1: 1 cover cassette (150 covers)
- Cover Tray 2: 1 cover cassette (150 covers)
- From the Off position: Approximately 2 minutes
- From the Energy Saver mode: Approximately 2 minutes
- Standard office outlet
- Europe: 230 VAC, 50 HZ
- North America: 115 VAC, 60 HZ
- Minimum: 17° C (63° F) at 15% relative humidity
- Maximum: 32° C (90° F) at 85% relative humidity
- Height to paper bridge 1450 mm (59 inches)
- Height to Output Tray: 965 mm (38 inches)
- Height to top of Output Tray cover: 1200 mm (48 inches)
- Width: 597 mm (23 1/2 inches)
- Width with paper bridge retracted 1617 mm (63 2/3 inches)
- Width with paper bridge extended 2217 mm (87 1/4 inches)
- Approximately 300 kg (660 lbs) with cassettes
- Run: 78 decibels
- Warm up: 800 watts
- Operation: 324 watts
- Energy Saver: 31 watts
- Warm up: 2730 BTU per hour
- Operation: 1106 BTU per hour
- Energy Saver: 108 BTU per hour
Technical data
Advertisement
Table of Contents
