Output Tray And Book Guide - Oce DFS10 Operator's Manual

Output Tray and Book Guide

The DFS10 delivers the bound books to its Output Tray, which is located on the right side of
the top of the DFS10. The Book Guide serves as a book end to hold the books in place in the
Output Tray. The Book Guide moves to the left as the books arrive in the Output Tray.
When the Output Tray is approximately half full, the message "Empty Top Output Tray"
will appear in the Message Display of the DFS10 Control Panel. If enabled, the Attention
Lamp will light and the Sound Tone will beep twice. The DFS10 will continue to operate.
Status "Full":
When the Output Tray is approximately three-quarters full, the message "Output Tray
Almost Full - Empty Top Output Tray" will appear in the Message Display of the DFS10
Control Panel. If enabled, the Attention Lamp will light and the Sound Tone will beep twice.
The DFS10 will finish binding the copy sets in process. You must empty the Output Tray of
the DFS10.
Status "Off-line":
When the Output Tray is full, the DFS10 will go off-line. The message "Output Tray Full
- Empty Top Output Tray" will appear in the Message Display of the Control Panel. If
enabled, the Attention Lamp will flash and the Sound Tone will beep every two seconds. You
must empty the Output Tray of the DFS10. You then must reset the DFS10.
Below is an illustration of the Output Tray and Book Guide.
1. Output Tray
2. Book Guide
3. Books
16 Getting to know the Océ DFS10