Oce DFS10 Operator's Manual page 52

Software Version
46
1. Enter the Customer Tools mode as instructed in the previous
section of this chapter.
2. Press the New Job button until Software Version appears on
the second line of the Cover Supply Contents Display.
3. Press the Manual Start button to accept Software Version.
NOTE: The software version level of the Main Board
EPROM, Interface board EPROM and UI Board EPROM will
appear in the Cover Supply Contents Display. This
information is read-only.
4. Press the Stop button to exit the Software Version feature.
5. Do one of the following:
• Press the New Job button until the next feature you want to
change appears on the second line of the Cover Supply
Contents Display.
• Press the Reset button to exit the Customer Tools features.
Customising your Océ DFS10