Loading Of Raid Controller Bios Stops Midway; Cannot Install The Os - Toshiba Magnia 3310 User Manual

If Something Goes Wrong
1 Are the CPU, memory, and keyboard properly connected?
See Connecting Hardware Devices
2 Run the BIOS Setup Utility to check the BIOS setup.
See BIOS Setup Utility

Loading of RAID controller BIOS stops midway

Probable causes are that the RAID controller and hard disk drive are not properly
connected, or that the RAID configuration is damaged or has not been built. Execute the
following procedure to isolate the problem. If this does not remedy the problem, proceed
to Remedy when Windows 2000 is Unusable
1 Is the RAID controller properly connected?
See Expansion cards
2 Is the Hard Disk Drive (HDD) properly connected?
See Hard disk drives (HDDs)
3 Execute the RAID controller utility to rebuild the RAID.
All data may be lost if the RAID is rebuilt. Refer to the RAID controller operating
manual for more information.

Cannot install the OS

A probable cause is that the hard disk drive is not being recognized by the OS. Execute
the following procedure to isolate the problem. If this does not remedy the problem,
proceed to Remedy when Windows 2000 is Unusable
1 Are the SCSI and RAID controllers properly connected?
See Expansion cards
manual.
2 Is the Hard Disk Drive (HDD) properly connected?
See Hard disk drives (HDDs)
3 Move the Hard Disk Drive (HDD) up in the bootup priority or the controller to which
that Hard Disk Drive (HDD) is connected.
See Cautions when adding RAID controllers and SCSI host adapters
4 When installing the OS, change the order in which the SCSI controller. RAID
controller and SCSI host adapter device driver are installed.
5 Disconnect backup devices (e.g. MO Disk Drive) if any are connected to the SCSI
controller before installing the OS.
on page 48.
on page 106.
on page 252.
on page 97. Also see the RAID controller operating manual.
on page 91.
on page 97. Also refer to the RAID controller operating
on page 91.
Common hardware problems
on page 252.
250
on page 98.