Table of Contents
Advertisement
Server Setup Tool
Onboard 1Gbps LAN Adapter (Ether1)
Can be used with the 1000Base-T/100Base-TX-TX/10Base-T ethernet LAN. This is
the default selection.
Onboard 100Mbps LAN Adapter (Ether2)
Can be used with the T/100Base-TX/10Base ethernet LAN.
The LAN driver for the onboard LAN adapter (Ether 2) must be installed,
regardless of the setting made on this screen. If the Onboard 100Mbps LAN
Adapter option is not selected, the onboard LAN adapter (Ether 2) will be setup
using the default Windows Server 2003 setting.
TCP/IP Protocol Setting-1
After specifying the LAN adapter, the TCP/IP Protocol Setting-1 screen appears. The
TCP/IP Protocol Setting-1 screen allows you to specify an IP Address, Subnet Mask and
Default Gateway Address for the on-board LAN Controller (1Gbps LAN Adapter).
TCP/IP Protocol Setting-1 screen
1
Enter an IP Address.
2
Enter a Subnet Mask.
3
Enter the Default Gateway Address.
To have the DHCP server automatically assign the IP addresses, Subnet Masks and
Default Gateway to your computer, select Assign an IP Address from DHCP
Server.
4
After making your entries, click Next.
130
Starting SST
Advertisement
Table of Contents
