Honda 2002 Accord Manual page 1509

12. Check for voltage between the No. 3 terminal of the
dashboard wire harness 6P connector C505 and
body ground. There should be battery voltage.
D A S H B O A R D W I R E H A R N E S S
6P
C O N N E C T O R
C505
1 2
3 4 5 6
W i r e s i d e o f f e m a l e
t e r m i n a l s
Is there battery voltage?
Y E S - O p e n in the S R S floor harness or OPDS unit
harness; if the OPDS unit harness is OK, replace the
S R S floor harness. •
NO —Open in dashboard wire harness A; replace
dashboard wire harness A.
13. Replace the No. 7 (7.5A) fuse in the driver's under-
dash fuse/relay box.B
14. Turn the ignition switch ON (II) for 30 seconds, then
turn it OFF.
15. Check the No. 7 (7.5A) fuse in driver's under-dash
fuse/relay box.
Is the fuse OK?
Y E S - F i n i s h e d . B
N O - G o t o step 16.
16. Replace the No. 7 (7.5 A) fuse in the driver's under-
dash fuse/relay box.
17. Disconnect dashboard wire harness connector I
(18P) from the driver's under-dash fuse/relay box.
18. Turn the ignition switch ON (II) for 30 seconds, then
turn it off.
19. Check the No. 7 (7.5A) fuse in driver's under-dash
fuse/relay box.
Is the fuse OK?
Y E S - G o to step 20.
N O - S h o r t to ground in the No. 7 (7.5A) fuse
circuit; refer to section 22 and continue
troubleshooting. •
20. Disconnect the S R S floor harness 6P connector
C505 (A) from the dashboard wire harness A 6P
connector (B).
(cont'd)
23-129