Caller Name Indication Selection - NEC Electra Elite IPK Programming Manual

Document Revision 4
___________________________________________________________________________________
3-53

Caller Name Indication Selection

General Description
When an Caller ID number is detected, the Electra Elite IPK system can check the
speed dialing buffer for a match. When a name is assigned to a matched number, the
name can be displayed, when allowed by this assignment.
Display
C O / P B X
N o .
D a t a
( 0 1 ~ 6 4 )
N o .
0 1 / 5 3 : I S
T I M E
Settings
LK 1 LK 2
NO NUM
Programming Procedures
G
1 Go off-line.
2 Press LK3 +
3 Press the corresponding CO/PBX line key to change the data option.
Use the following to enter data:
J
t o move the cursor left
L
t o move the cursor right
K I
~ t o enter numeric data or CO/PBX No.
D
– OR –
to go to the next assigned CO/PBX No.
Settings include:
NO Disables caller name display.
NUM Selected when system speed dial buffers are assigned a number; the number is displayed when Caller ID
number matches a speed dial number.
NAM Selected when system speed dial buffers are assigned a name; the name is displayed when it is assigned to a
matched number and Caller ID number matches the speed dial number.
TRK Selected if you want the trunk name or number to be displayed when data is assigned in Memory Block 3-00
G
(Trunk Name/Number Assignment).
4 Press to write the data and display the next Memory Block.
5 Program the next Memory Block or press
Related Programming
Refer to individual features in the Electra Elite IPK Features and Specifications Manual.
___________________________________________________________________________________
2 - 480
S e t t i n g
T i t l e
D a t a
I N D N U M
D I S P L A Y
LK 3 LK 4
NAM
E C
+ to access the Memory Block.
E
LK 5 LK 6
TRK
to go back on-line after all data is written.
CO/PBX Line Mode
PC Programming
LK 7 LK 8 The shaded
selection is the
default.
Electra Elite IPK
3
Submode
—
Data No.
53
+AI
Memory Blocks