Co/Pbx Ringing Variation Selection - NEC Electra Elite IPK Programming Manual

Electra Elite IPK
___________________________________________________________________________________
3-07

CO/PBX Ringing Variation Selection

General Description
Use this Memory Block to specify a ringing tone for each CO/PBX line.
Display
C O / P B X
D a t a
N o .
N o .
( 0 1 ~ 6 4 )
0 1 / 0 7 : D S T
T I M E
Settings
LK 1 LK 2
M L
(Medium) (Low)
Programming Procedures
G
1 Go off-line.
2 Press LK3 + +
3 Press the corresponding CO/PBX line key to change the ringing tone for CO/PBX.
Use the following to enter data:
J
t o move the cursor left
L
t o move the cursor right
K I
~ t o enter numeric data or CO/PBX No.
D
– OR –
G
to go to the next assigned CO/PBX No.
4 Press to write the data and display the next Memory Block.
5 Program the next Memory Block or press
Related Programming
M.B. Number Memory Block Name
1-1-28 Distinctive Ringing by Telephone or CO Selection
1. This Memory Block is not applicable when Telephone is selected in Memory Block 1-1-28 (Distinctive Ringing by
Telephone or CO Selection).
2. High, medium, or low ringing tone applies to incoming outside line calls only.
___________________________________________________________________________________
Programming Manual
S e t t i n g
T i t l e
D a t a
R I N G = M
D I S P L A Y
LK 3 LK 4 LK 5
H
(High)
K G
t o access the Memory Block.
E
to go back on-line.
LK 6 LK 7
Notes
Document Revision 4
CO/PBX Line Mode
3
Submode
—
Data No.
07
PC Programming
+BCT
LK 8
The shaded
selection is the
default.
2 - 433