1-15-08 Link Reconnect Allow/Deny Selection; K-Ccis Maximum Call Forwarding Hop Assignment - NEC Electra Elite IPK Programming Manual

Document Revision 4
___________________________________________________________________________________

1-15-08 Link Reconnect Allow/Deny Selection

General Description
Use this Memory Block to allow or deny the Link Reconnect feature.
Display
D a t a
N o .
0 8 : R E C O N N E C T
T I M E
Settings
LK 1 LK 2
NO YS
(Allow)
(Deny)
Programming Procedures
1 Go off-line.
K H
2 Press LK1 + LK15 +
3 Press the corresponding CO/PBX line key to change the option.
G
4 Press to write the data.
E
5 Press to go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1 Card Interface Slot Assignment
7-3-01 MIF (LCR) Assignment
7-3-02 MIF (SMDR) Assignment
1-15-00 K-CCIS Main/Remote Office Selection
1-15-01 Common Signal Channel Data Speed Assignment
1-15-02 Common Signal Channel Assignment
1-15-03 Originating Point Code Assignment
1-15-04 Destination Point Code Assignment
1-15-05 Destination Point Code Transfer Assignment
1-15-06 Originating Office Code Number Assignment
1-15-07 K-CCIS Message Response Timeout Assignment
1-15-09

K-CCIS Maximum Call Forwarding Hop Assignment

___________________________________________________________________________________
2 - 350
S e t t i n g
D a t a
T i t l e
Y S
D I S P L A Y
LK 3 LK 4 LK 5
to access the Memory Block.
LK 6 LK 7 LK 8
Electra Elite IPK
System Mode
1
Submode
15
Data No.
08
PC Programming
+AW
The shaded
selection is the
default.
Memory Blocks