Lcd Line Key - Name Assignment (Station Add-On Console) - NEC Electra Elite IPK Programming Manual

Document Revision 4
___________________________________________________________________________________
4-70 LCD Line Key – Name Assignment
(Station Add-On Console)
General Description
Use this Memory Block to assign a name to each Station Add-On Console. Up to
eight characters can be assigned per line key.
R4000 or higher is required to support the Add-On Console.
Display
T e l P o r t
N o . D a t a
( 0 1 ~ C O ) N o .
0 1 / 7 0 : D S 0 1
<
Setting Data
Programming Procedures
1 Go off-line.
G K
2 Press LK4 +
3 Use the dial pad to change line key number or name.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K I
t
~ o enter numeric data or Tel Port No.
D
– OR –
B
to go to next assigned Tel Port No.
B
A
+
B
B
+
C
+
G
4 Use dial pad to enter characters for each line key.
5 Press to write the data and display the next line key and name.
6 Repeat step 4 for each line key assignment. After Line Key 16 is programmed, the
next Memory Block is displayed. For less than 16 line keys, after the last line key
to be programmed, press
7 Program the next Memory Block or press
___________________________________________________________________________________
2 - 594
L K N o
0 1 ~ 1 6 N a m e
N A M E 5
>
to access the Memory Block.
t o enter A for Port Numbers 100~109
t o enter B for Port Numbers 110~11
t o enter C for Port Number 120
D
E
to go to next Tel. Port No.
to go back on-line.
Electra Elite IPK
CO/PBX Line Mode
Submode
PC Programming
Default Value
LK01~16: Blank
Memory Blocks
4
—
Data No.
70
+BTM