Caller Id Display Assignment For Co/Pbx Line - NEC Electra Elite IPK Programming Manual

Electra Elite IPK
___________________________________________________________________________________
3-44 Caller ID Display Assignment for CO/
PBX Line
General Description
Use this Memory Block to assign one Multiline Terminal to display ANI/Caller ID
Indication for incoming CO/PBX calls per CO/PBX line.
This Memory Block is used for R1600 and lower. For R1700 or higher, it is no longer
required.
Display
C O / P B X
N o . D a t a
( 0 1 ~ 6 4 ) N o .
0 1 / 4 4 : C A L L I D
T I M E
Programming Procedures
G
1 Go off-line.
2 Press LK3 + +
3 Enter data for CO/PBX No. using the dial pad to assign ANI/Caller ID to a station.
Use the following to enter data:
J
t o moves the cursor left
L
t o moves the cursor right
K I
~ t o enter numeric data or CO/PBX No.
D
– OR –
to go to the next assigned CO/PBX Line No.
Enter the following:
Tel Port No. 01~CO
G
CO/PBX No. 01~64
4 Press to write the data and display the next Memory Block.
5 Program the next Memory Block or press
Related Programming
Refer to individual features in the Electra Elite IPK Features and Specifications Manual.
___________________________________________________________________________________
Programming Manual
T e l
P o r t N o .
T i t l e
0 1 ~ C 0
D I S P L A Y
D D
t o access the Memory Block.
E
to go back on-line.
Document Revision 4
CO/PBX Line Mode
Submode
Data No.
PC Programming
Default Values
No Assignment
3
—
44
+AI
2 - 475