NEC Electra Elite IPK Programming Manual page 608

Electra Elite IPK
___________________________________________________________________________________
Programming Procedures (Continued)
3 Press the CO/PBX line key corresponding to each CO/PBX line.
The LED indication changes to indicate data each time a CO/PBX line key is pressed.
CO/PBX
Line Key LED
Data
Use the following to enter data:
J
t o move the cursor left
L
t o move the cursor right
K I
~ t o enter numeric data or Tel Port No.
D
– OR –
C
to go to next assigned Tel Port No.
A
to go to the next page
H
to go to the previous page
B
to clear data when cursor is at setting data position
B A
+
B
B
+
C
G
+
4 Press to write the data and display the next Memory Block.
5 Program the next Memory Block or press
1. A restricted CO/PBX line allows the station user to answer an incoming call or access a held call, but does not
allow a user to originate a CO/PBX call.
2. When restricted is specified in this section, the data in Memory Blocks 4-07 [Code Restriction Class Assignment
(Day Mode)] and Memory Block 4-08 [Code Restriction Class Assignment (Night Mode)] is treated as invalid
even if specified.
3. Telephone ports A0~C0 are ports 100~120.
___________________________________________________________________________________
Programming Manual
Off On
Not Restricted Restricted
t o enter A for Port Numbers 100~109
t o enter B for Port Numbers 110~119
t o enter C for Port Number 120
E
The shaded selection
is the default.
to go back on-line.
Notes
Document Revision 4
Default Values
Not Restricted
2 - 531