NEC Electra Elite IPK Programming Manual page 467

Document Revision 4
___________________________________________________________________________________
Related Programming
M.B. Number Memory Block Name
7-1 Card Interface Slot Selection
1-16-00 Auto Negotiation Yes/No Selection
1-16-01 Port Speed Selection – 10/100 Base T
1-16-02 Port Duplex Mode Selection
1-16-03
MDI/MDIX Mode Selection
1-16-04
VLAN Mode Selection
1-16-06
Port Based Priority Selection
1-16-07
High Priority RX Tag Threshold
1-16-08 High Priority TX Tag Assignment
1-16-09 Low Priority TX Tag Assignment
1-16-10 Port Mirroring Selection
1-16-11 Mirroring Source Port Assignment
1-16-12 Mirroring Target Port Assignment
1-16-13 VLAN Group to VLAN ID Assignment
1-16-14
Port VLAN Group Membership
1-16-15
VLAN Tag Insertion Selection
1-16-16
Flow Control for Full Duplex Selection
1-16-17
Back Pressure for Half Duplex Selection
1. Only one HUB(8)-U( ) ETU can be assigned and installed per cabinet.
2. When Memory Block 1-16-04 (VLAN Mode Selection) is set to YS, this port based Tag VLAN feature can be
used. In the Tag VLAN mode, a received packet is switched according to a combination of the MAC address and
VLAN ID. When the incoming packet is not tagged or the VLAN ID = 0, the VLAN ID is set to the default ID
specified by this Memory Block.
___________________________________________________________________________________
2 - 390
Notes
Electra Elite IPK
Memory Blocks