NEC Electra Elite IPK Programming Manual page 441

Document Revision 4
___________________________________________________________________________________
1-15-15 Centralized BLF Send Point
Code Assignment
General Description
Use this Memory Block to assign the Destination Point Codes and the CCH Channel
of systems to be sent Centralized BLF messages. A CCH Channel of i can be
assigned for K-CCIS over IP.
R1500 or higher is required.
Display
D a t a
N o .
T i t l e
1 5 : S E N D 1 :
T I M E
Programming Procedures
1 Go off-line.
A E
2 Press LK1 + LK15 +
3 Use dial pad keys to enter Group No., CCH Channel, and Point Code.
Press Redial + 1 to assign i for K-CCIS over IP (R1500 or higher).
Use the following to enter data:
J
t o move cursor left
L
t o move cursor right
K I
~ t o enter numeric data
Point code range is 00001~16367.
Group No. 1~8 can be assigned.
G
4 Press to write the data, and display the next Memory Block.
5 Repeat Steps 3 and 4 for each Group No.
6 Program the next Memory Block or press
Related Programming
M.B. Number Memory Block Name
7-1
Card Interface Slot Assignment
1-8-08
Class of Service (Station) Feature Selection 2 (Page 6, LK 2)
1-15-00 K-CCIS Main/Remote Office Selection
1-15-01 Common Signal Channel Data Speed Assignment
1-15-02 Common Signal Channel Assignment
___________________________________________________________________________________
2 - 364
G r o u p C C H
P o i n t
C h a n n e l
N o .
C o d e
1 ~ 8 1 ~ 4 , i
= 0
D I S P L A Y
to access the Memory Block.
E
to go back on-line.
Electra Elite IPK
System Mode
Submode
Data No.
PC Programming
Default Values :
All Tables Not Specified
Memory Blocks
1
15
15
+AW