NEC Electra Elite IPK Programming Manual page 119

Document Revision 4
___________________________________________________________________________________
Related Programming
M.B. Number Memory Block Name
3-03 Trunk-to-Trunk Group Assignment
1. When 00 (Not Set) is programmed, no trunks are accessed for this priority setting.
2. When Route Advance Block Numbers are assigned and a line key is pressed or an Access Code is dialed, the
system starts searching for an idle line in a specified group (beginning with the Trunk group assigned priority 1).
3. When all CO/PBX lines are in use, the line with the next highest priority is seized.
4. Route Advance Block Number Access Codes are defined in Memory Block 1-1-46 [Access Code (1-Digit)
Assignment] or Memory Block 1-1-47 [Access Code (2-Digit) Assignment] function number 201~232.
5. Press the Transfer key repeatedly to cycle through four priorities for each Block sequentially until all Blocks are
covered, and then advance to the next Memory Block. The Trunk Group must be added using the dial pad keys.
___________________________________________________________________________________
2 - 42
Notes
Electra Elite IPK
Memory Blocks