Caller Id Display Assignment For System Mode - NEC Electra Elite IPK Programming Manual

Document Revision 4
___________________________________________________________________________________
1-1-78 Caller ID Display Assignment for
System Mode
General Description
Use this Memory Block to assign up to 15 Multiline Terminals to display ANI/Caller ID
Indication for normal incoming CO/PBX calls or CO/PBX calls ringing a Call Arrival
(CAR) key.
This Memory Block is used for System Software R1600 and lower. For System
Software R1700 and higher it is no longer required.
Display
D a t a
N o .
7 8 : C A L L I D
T I M E
Programming Procedures
1 Go off-line.
G H
2 Press LK1 + LK1 +
3 Use the dial pad to enter Entry No. 01 and Tel Port No.
Use the following to enter data:
J
t o move the cursor left
L
t o move the cursor right
K I
~ t o enter numeric data
G
4 Press to write the data and advance to the next Entry No. After each tel port No. is selected, press
of 15 entries can be made. After the last data is entered, the next Memory Block is displayed.
5 Program the next Memory Block or press
1. To display ANI/Caller ID Indication for normal incoming and CAR incoming calls, Caller ID Indication and Ring
Assignment must be programmed.
2. Fifteen Multiline Terminals can be assigned system-wide to display ANI/Caller ID.
3. A sixteenth terminal can be assigned to display ANI/Caller ID using another Memory Block.
___________________________________________________________________________________
2 - 98
T e l P o r t N o .
( 0 0 ~ 9 9
E n t r y
A 0 ~ A 9
N o . B 0 ~ B 9
0 1 ~ 1 5
T i t l e
0 1 =
D I S P L A Y
to access the Memory Block.
E
C O )
to go back on-line.
Notes
Electra Elite IPK
System Mode
Submode
PC Programming
Default Values
Not specified
G
Memory Blocks
1
1
Data No.
78
+AI
again. A total