Pause Time Selection - NEC Electra Elite IPK Programming Manual

Document Revision 4
___________________________________________________________________________________
1-1-00

Pause Time Selection

General Description
Use this Memory Block to specify the pause time that can be inserted between digits
dialed on CO/PBX and Tie lines.
Display
D a t a
N o .
0 0 : P A U S E
T I M E
Settings
LK 1 LK 2
1.0s 3.0s
Programming Procedures
1 Go off-line.
K K
2 Press LK1 + LK1 +
3 Press the corresponding CO/PBX line key to change the data option.
G
4 Press to write the data and display the next Memory Block.
5 Program the next Memory Block or press
Related Programming
M.B. Number Memory Block Name
1-1-09 Manual Pause Selection
1-1-24 PBX/CTX Access Code Assignment I
1-1-25 PBX/CTX Access Code Assignment II
3-91 Trunk Type Selection
1. A pause is automatically inserted following a CO/PBX Access Code (e.g., 9) by programming CO/PBX lines as
PBX in Memory Block 3-91 (Trunk Type Selection) and 1-1-24/25 (PBX/CTX Access Code Assignment I/II).
2. Manual pauses can be stored for use when dialing outside lines by the Last Number Redial or Save/Store and
Repeat features using Memory Block 1-1-09 (Manual Pause Selection).
3. Pauses can be stored as part of System and Station Speed Dial buffers when needed.
___________________________________________________________________________________
2 - 2
D a t a
T i t l e S e t t i n g
3 . 0 s
D I S P L A Y
LK 3 LK 4
to access the Memory Block.
E
to go back on-line.
LK 5 LK 6 LK 7
Notes
Electra Elite IPK
System Mode
1
Submode
1
Data No.
00
PC Programming
+BCM
LK 8 The shaded
selection is the
default.
Memory Blocks