Exit Rollers
Sensor
Floor Assembly
and Top Cover
If the right and left exit rollers are misaligned, that is, contact
printed surfaces, they can become contaminated with ink. Use
water to dampen a soft cloth and remove the ink from the rollers.
A film and/or dust can build up on the sensors and cause
misfeeds of the material. Lift the back cover and use compressed
air to blow dust from the sensors. Cans of compressed air are
available from many computer supply houses.
Periodically wipe the top cover and floor assembly (feed deck)
with a soft cotton cloth, dampened with water only.
Maintenance
Sensor Location
5-3