Load Material; Load Materials - Pitney Bowes DA300 Operating Manual

Setting Up A
Job (continued)

5. Load Material

Once your printer is set up, you can load material and make a test
print..
To avoid misfeeds, follow these instructions
l. Make sure the input area is free of dust and other matter.
2. Take a manageable amount of material and while holding
it as shown, fan all sides of the material to separate each
piece. This step helps keep misfeeds to a minimum.
3. Tamp the material on a flat surface, making sure that the
stack is square.
4. Shingle the stack as you load it into the input area. Load
envelopes so the side to be printed faces up. Flaps should
be down and oriented away from the feed roller (flaps
trailing). Begin with just a few envelopes to start the stack
and get the proper contour, then add several more pieces.
Then add the remainder of the stack.
5. Adjust the position of the material prop as described on
the next page.
Basics
3-11