Cleaning The Exit And Entry Idler Rollers; Cleaning The Sensors - Pitney Bowes AddressRight DA Series Operator's Manual

3 • Printer Maintenance

Cleaning the Exit and Entry Idler Rollers

From normal operations of the printer the exit idler rollers and entry
idler rollers can accumulate a buildup of ink, wax, etc. which will
require removal or the idlers will leave marks on the material.
Use alcohol on a soft cloth to remove any ink, wax etc. from the
rollers. You can swivel the print head assembly out of the way for
better access.
Entry Idler Rollers

Cleaning the Sensors

With use, a film and/or dust
builds up on the eye of the
sensors causing misfeeds
of material. Periodically use
compressed air to blow dust
from the sensors. For caked
on dust use a cotton swab to
remove the dust from the eye
of the sensor.
NOTE: The lower half of the
Sensor is seen through the
holes in the floor for the entry
roller closest to the rear wall of
the printer.
3-8
Exit Roller
Upper Sensor
Lower Sensor
Exit Idler Rollers
SV61722 Rev. D