Attaching The Material Prop; Attach The Material Prop - Pitney Bowes DA300 Operating Manual

Assembling the
DA300
(continued)

1. Attach the Material Prop

1. The material prop has three grooves on its back side Place
it on the wire frame so the grooves engage the bars of the
frame and the hole for the lock knob is facing up.
2. Place the small washer on the lock knob.
3. Push the threaded portion of the lock knob through the
hole in the material prop.
4. Position the plastic clamp and nut plate on the other
side of the material prop and turn the lock knob clock-
wise until the prop is secure.
The position of the material prop will change, depending
on the material you run. You'll find out how to adjust it
in the next chapter.
Setup
Wireframe
Input Stacker
Lock Knob
Clamp
Nut Plate
Material Prop
2-7