Attach The Wireframe To The Printer - Pitney Bowes DA300 Operating Manual

Setup
Assembling the
DA300
(continued)
2-8
2. Attach the Wire Frame to the Printer.
1. Hook the bottom
edge of the wire
frame under the tabs
in the frame slide.
2. Rotate the wire frame
and insert the curved
metal bar on the
bottom of the frame
into the height
adjustment slot. See
the photo on the next page.
3. Adjust the height of the wireframe so it's positioned at
about a 45 degree angle. Turn the lock knob on the side
of the slide clockwise to hold the wireframe in position.
You can adjust both the height and side-to-side position
of the wireframe to accommodate the size and type of
the material you're running. We talk about this in the
next chapter.
Tabs Lock Lever
Height Adjust- Lock Knob
ment Slot