Setting Up The Da300; Choosing A Location For Your Printer; Choosing A Location - Pitney Bowes DA300 Operating Manual

Setup
Setting Up the
DA300
Choosing a
Location for
Your Printer
2-4
The assembled printer should look like the picture below. The
parts you have to put together are identified.
Wireframe Input Material Prop
Stacker and Lock Knob
Refer to this picture as you set up your printer. Follow the steps
on pages 2-7 through 2-14.
Follow these guidelines and safety precautions when selecting a
location for your printer.
•
Place the printer on a table or other stable, level surface
within the parallel cable's length (3 metres [10 feet]
maximum) of your computer.
•
Allow for adequate space. The DA300 is 370mm (14.7")
high, 410mm (16.2") wide and 550mm (21.7") deep,
without the wire frame input stacker.
•
Allow for adequate ventilation around the base and rear
of the printer.
•
Protect the printer from heat, dust and moisture. Avoid
placing the printer in direct sunlight.
Output Stacker
Sliding Feed
Fence (Not Shown)