Adjust The Position Of The Material Prop - Pitney Bowes DA300 Operating Manual

Basics
Setting Up A
Job (continued)
3-12

6. Adjust the Position of the Material Prop

With a stack of material loaded:
1. Loosen the lock knob that holds the prop in position.
2. Lower the prop until its top is even with the top of the
stack or the top of the stack reaches the middle of the
prop.
3. Tighten the material prop's lock knob to hold it in
position.
At this point, it's a good idea to recheck your setup adjustments:
• Is the separator gap adjustment correct?
• Is the wireframe centred under the material?
• Is the feed angle okay?
• Is there a slight clearance between the feed fence and the edge of
the stack?
Material Prop