Install The Ink Jet Cartridge; Removing The Ink Jet Cartridge - Pitney Bowes DA300 Operating Manual

Installing and
Removing the
Ink Jet
Cartridge

7. Install the Ink Jet Cartridge

The printer uses an Ink Jet Cartridge for printing. You must
install the cartridge before you can print. To begin:
1. With the printer on, press the On Line key until the
display reads OFF LINE.
2. Open the back cover of the printer.
3. Press the + key on the control panel to move the carriage
to the middle of the printer.
4. Remove the cartridge from its shipping container by
peeling the top cover off. Be careful not to touch the
copper ribbon.
WARNING! The ink in the cartridge may be
harmful if swallowed. Keep new and used car-
tridges out of reach of children. Discard empty
cartridges immediately.
5. Gently remove the tape covering the ink nozzles on the
print cartridge, being careful not to touch the copper
nozzles.
6. Gently insert the cartridge into the carriage at approxi-
mately a 45 degree angle with the green arrow on the
cartridge top pointing toward the inside of the printer.
Setup
2-13