Set The Feed Angle - Pitney Bowes DA300 Operating Manual

Setting Up A
Job (continued)

3. Set the Feed Angle

The feed angle of the wireframe input stacker depends on the
type of material you're running:
Heavy material—adjust to a low angle
•
Standard material—adjust to the centre (45 degree angle)
•
Light material—adjust to a high angle
•
To make the adjustment:
1. Loosen the lock knob on the wireframe slide.
2. Move the wireframe up or down as required.
3. Tighten the lock knob to secure the wireframe.
Wire Frame
Lock Knob
Basics
3-9