Oki OKIFAX 5950 Series Maintenance Manual page 26

No. Item
29 Image transmission time
30 Error correction scheme (ECM)
31 Communication mode
32 Ringing signal detection sensitiv-
ity
OF5750/5950 Series January 2001
2.5 seconds at 33.6 kbps with JBIG for OKIFAX 5950
and 3.0 seconds at 33.6 kbps for OKIFAX 5750 per
sheet of ITU-T No.1 evaluation test chart.
Note: This speed denotes the time interval corre-
sponding to Phase C (message transmission
phase) as referred to in ITU-T T.30.
OKIFAX 5750
Initial
Procedure
Intermediate
Time
G3
Final
Basic
Image 33600 Standard
Time Fine
Note: The above table shows the values under the
following conditions:
• Sender ID: OFF
• High-speed protocol: OFF
• Transmission mode: Memory
• Resolution: STD
ITU-T ECM defined in T4, T.30 are provided.
Half-duplex
1) Voltage range
• 25 to 150 V r.m.s.
Inoperative below 10V
Note: This range may differ by the requirement of
PTT.
2) Frequency range
• 16 to 68 Hz
Note: This range may differ by the requirement of
PTT.
3) Ring response time
• One-ringing signal or 5 sec, 10 sec, 15 sec, and
20 sec selectable
1 - 17
Specifications
OKIFAX 5950
8.5 sec. (V34) Initial 8.5 sec. (V34)
1.0 sec. (V34) Intermediate 1.0 sec. (V34)
1.0 sec. (V34) Final 1.0 sec. (V34)
3.0 sec. 33600 Standard
4.2 sec. Fine
2.5 sec.
3.5 sec.