Oki OKIFAX 5950 Series Maintenance Manual page 149

Table 2.9.2.3 Technical Functions: Setup (4/11)
No. Item
12 MH Only
13 H/MODEM Rate
14 T1 (TX) Timer Value
15 T1 (RX) Timer Value
16 T2 Timer *100MS
OF5750/5950 Series January 2001
Determine whether only MH coding is to be handled forcibly.
This setting is required when the line noise affects the received
image.
1) Setting values
ON (MH only)/OFF (JBIG; only OKIFAX5950, MMR, MR, or
MH is selected depending on communication capacity)
Set the initial value of modem transmission speed.
1) Setting values
33.6/28.8/14.4/9.6/4.8K
Set the T1 timer (call connection wait time: XTTO) for transmis-
sion.
T1 (TX) is a time to detect up to 3 flags of DIS sent from a
called fax machine.
This timer sets the time that lapses from the moment the last
digit has been transmitted to the moment the line is discon-
nected.
1) Setting values
10-255 selectable (in 1 second steps)
* Enter a value using ten-keys.
Set the T1 timer for reception.
T1 (TX) is a time to detect up to 3 flags of DIS sent from a
called fax machine.
The time from issue of the first DIS to issue of a signal is
checked. If a time-out occurs, the line is disconnected.
1) Setting values
10-255 selectable (in 1 second steps)
* Enter a value with ten-keys.
Set the T2 timer.
The T2 timer is an EOL (End Of Line) signal interval timer used
for G3 image reception or an instruction reception wait timer.
If any signal cannot be detected within the timer-set time, the
fax disconnects the line.
1) Setting values
1-255 selectable (in 100 ms steps)
* Enter a value with ten-keys.
* Actual value = (Set value) x 100 ms
Suppose the set value is 060, then
060 x 100 ms = 6 s
2 - 42
Specifications