Oki OKIFAX 5950 Series Maintenance Manual page 198

No. Item
26 Power Save Mode
27 Relay Print
28 600DPI Function
29 ISDN Dial Mode
OF5750/5950 Series January 2001
Table 2.9.5.3 Machine Settings (5/6)
Determine whether the current mode is to be switched to the
Power Save mode.
The power supply will be fed to all circuits of a fax machine
whenever the fax goes to the operating state. The power save
mode has reduced the power consumption at standby to below
xxW.
1) Setting values
ON (Switched)/OFF (Not switched)
* When Default Type is set to 1 and Country Code is set to
USA, the Power Save mode cannot be selected.
* This mode cannot be made when LAN board is installed.
Sets up whether to print picture received during relay reception.
1) Setting value
ON (print)/ OFF (not print)
* When in MEM mode, no printing if this setting is ON.
* In the case of OKIFAX 5750 device, setting is skipped.
(Only OKIFAX 5950 is operable.)
Sets up whether to effect communication and/or printing with
600 DPI x 600 DPI.
1) Setting value
ON/OFF
ON: Of 8MB memory, the DRAM area for 4MB is set aside
as a shared area for print buffer and the picture stor-
age. Only when this area is not in use, 600 dpi com-
munication (transmission-reception) and copying will
be enabled.
OFF: Option memory of 8MB is all used for storing pictures.
Therefore, resolution of communication and copying
remain unchanged from conventional data (not for 600
dpi).
* Setting enabled only when 8MB optional memory is in-
stalled. If pictures received with 600 dpi are present in the
picture memory, "ILLEGAL OPERATION" warning will be
displayed when shifting to the lowest hierarchy.
Determine whether G4 communication is to be performed by
calling a single remote machine by pressing ten-keys when an
ISDN option is provided.
1) Setting values
G3 MODE (G3 communication)/G4 MODE (G4 communica-
tion)
* This setting cannot be made when an ISDN option is not
provided.
2 - 91
Specifications