Oki OKIFAX 5950 Series Maintenance Manual page 146

2.9.2.3 Technical Functions (Setup)
• Table 2.9.2.3 shows the initial setting items and their purpose. (The default setting is different
by the individual countries.)
• Each item can be accessed by entering it on Technical Setup.
• The detailed procedures of the initial settings items will be explained on the following tables.
The setting data must be transferred to the G3 Option side.
(encluding LLC CHECK, G3/G4 LEARNING, GATEWAY SERVICE, EMAIL MAINTENANCE,
ADMIN EMAIL ADDR. and COMMAND T.O.)
Table 2.9.2.3 Technical Functions: Setup (1/11)
No. Item
01 Service Bit
02 Monitor Cont.
03 Country Code
04 Time Date Print
OF5750/5950 Series January 2001
Enables the serviceman to make special settings.
If this setting is OFF, some settings and report print function
may become unavailable.
1) Setting values
ON: Enables the serviceman to make settings.
OFF: Disables the serviceman to make settings.
Sets up the line monitor.
If this setting is OFF at the time of transmission, the line is
monitored during dialing but the line will not be monitored after
a specified time lapse (about 5 sec).
If this setting is ON, the line will be monitored till the end of
communication.
G3 option line can be monitored.
1) Setting values
ON (Monitored continuously)/OFF (Not monitored continu-
ously)
* The tone level can be adjusted by setting Monitor Volume.
Set a country code.
1) Setting values
Select a country code from:
USA/INT'L/GBR/IRL/NOR/SWE/FN/DEN/GER/HUN/TCH/
POL/SUI/AUT/BEL/HOL/FRE/POR/ESP/ITA/GRE/AUS/NZL/
SIN/HNG/LTA/MEX/RUS
Determine whether the date and time set on the local machine
are to be printed at the beginning of the received image.
1) Setting values
OFF (Not printed)/ONCE (Printed on page 1 only)/ALL
(Printed on all pages)
2 - 39
Specifications